To configure Aastra VoIP phones to connect to the Freevoice PBX you must know the IP address of your server and extensions for the phones must be created in FreePBX and added in the endpoint manager. In many cases the phone will need to be reset to factory defaults, in order to accept the endpoint manager settings, see the bottom article. If this is a new installation, or you have changed the server ip make sure the setup-aastra command has been run from the linux cli.

Resetting Aastra Phones to Factory Default

1. Press the Options key on the phone
2. Scroll down to Admin Settings
3. Press the enter key
4. Enter the default admin password 22222
5. Scroll down to Factory Default
6. Press the enter key
7. Select All Defaults
8. Then press the # key to confirm 
9. The phone will reset, after it is done follow the instructions below.

Aastra 9143i & 9xxxi Configuration Server Setup:

*Note: If the phone has firmware version 2.4 or higher it should automatically perform this next step. When the phone reboots after the steps above check for the extension number to show up on the display, that means the phone has configured itself. Otherwise perform the steps below.

1. Press the Options key on the phone
2. Scroll down to and select Admin Settings
3. Enter the default admin password 22222
4. Scroll down to and select
5. Scroll down to and select TFTP Server
6. Scroll to and select Alternate TFTP
7. Enter the IP address of server using the dial pad, use the * key for dots. Press the set key when done.
8. Scroll to 3. Use Primary and press the change key, the screen should then show alternate.
9. Press the hangup key, then press # to restart the phone
10. If everything is configured properly the phone will download the config files and register with the server.